Stone and laminate tiles, rubber and plastic mats, or even steel and aluminum plate decking are a number of the well-known ways of protecting garage floors.
Although, these ways give excellent results, they are generally extremely expensive for the typical homeowner. Epoxy coating has been tested and proven to be the absolute most economical and functional way of protecting floor grinder for the typical homeowner.
Epoxy is a resin that strongly binds to concrete thus giving a strong and durable finish that is usually resistant to both chemicals and stains. The nice side with epoxy is that it’s obtainable in a number of finishes that vary from dull to glossy. The paint also exists in a endless number of colors.
The most appealing section of epoxy is that you never require special skills to apply it; therefore, you are able to use it on your own; however, if you will need a professional touch, you are able to hire a professional to accomplish it for you.
Exactly like any do-it-yourself project, preparation is the key to success. The paint does not bind on a dirty surface; therefore, you must make sure that a floor where you wish to apply the paint is free from any dirt, oil, paint, and gravel. You basically have to eliminate most of the’bad stuff’when you apply the’good stuff.’
When you have thoroughly cleaned a floor, you must allow it time for you to dry. If a floor had been sealed before, you must remove the old sealer. One of the greatest machines that you should use to eliminate the sealer is a floor grinder.
Once the sealer has been removed you must then reseal the cracks and chips with the brand new sealer. To open concrete pores, you should use a chemical’etcher.’
For ideal results, you must apply two coats of the paint. When you apply the initial coat, you must leave it overnight to dry when you apply the second coat. If you want a super elegant finish, you should use a definite top-coat as the final layer.
Epoxy will harden over time and you need to be in a position to walk on it within 12 hours. To prevent damaging the paint, it’s recommended that you give it at least four days to dry when you drive on it.
This is how you protect your garage floor using Epoxy paint. When buying the paint, you must make sure that you purchase it in reputable stores that won’t rip you off.
You will find various kinds of floor surface preparation types that concrete services contractors use to begin any project. An essential point to keep in mind is that the business hired must have the experience in carrying out the industrial flooring preparation process. These methods have specialized equipment and contractors don’t usually give you a service not unless they’re equipped to accomplish the work. A floor surface preparation process is a vital step in industrial flooring.
You could try and sweep a floor but to learn avail, the dust keeps coming back. Now you may figure that you’ve done your very best trying to completely clean the outer lining and what the heck I’ll just paint a floor, maybe add a few extra coats. This doesn’t work since garage floor epoxy paint won’t adhere to dust for long. Needless to say it will appear good when you’re done but that’s the last time it will appear good and goes downhill from there. You could even notice within a couple of days a few small chips. From there it just gets worse.
There are certainly a few solutions that will assist increase the adhesion of floor paint. Begin by checking your floor for signs of moisture. Put a plastic mat down on the floor or tape plastic to the outer lining in a few spots and wait a few days. If you find condensation or it gets wet underneath you will require an epoxy waterproof coating that works as a topical moisture barrier.
If a floor is free from moisture or is above a basement you must etch or have a floor mechanically prepped with a shotblaster or floor grinder. It is very important with concrete to profile the outer lining area providing more floor for the paint to stick to. Many manufacturers suggest an acid etching solution. The problem by having an acid etch with a liquid is that you will be applying a really diluted ineffective solution on the floor. You might feel great that you etched the outer lining but it probably didn’t work. Along with a diluted acid concrete is never flat. The water and acid solution will flow to the lower spots having minimal affect the high spots.Read More